Publish to Kaltura

TechSmith Relay can automatically publish presentations to Kaltura and Kaltura MediaSpace™.

Custom Data in Kaltura

To allow TechSmith Relay to publish to Kaltura, your Kaltura account must have Custom Data enabled. To verify this option is enabled, log in to your Kaltura administrator account and go to Settings.

If you do not see a Custom Data tab under Settings, please contact Kaltura support.

Configure TechSmith Relay to Publish to Kaltura

  1. Go to Profiles > Publish Destinations.
  2. Click Kaltura on the left to create a new destination.
  3. Enter a title for the publish destination.
  4. Enter the Service URL.
  5. Enter the Partner ID and Administrator Secret.

    To locate this information, log in to the Kaltura Management Console and go to Settings > Integration Settings.

  6. Click Save.

    The publish destination is saved and you are presented with a link to the Publish Account Setup for this destination. See Kaltura Publish Accounts for additional information.

  7. Click the link to continue with Publish Account Setup.

Tip: If the publish destination you would like to use is not available in the list of publish destinations, you may have to install the appropriate plug-in before you can use it. See Plug-Ins for more information.

See also

Was this article helpful?
0 out of 0 found this helpful